Feeds:
Posts

## The Pattern in Non-alternating Labyrinths

Up to now we have always considered the patterns of alternating labyrinths. Most of all well-known labyrinths are alternating. In these labyrinths, the pathway does not traverse the (main) axis. Every time when it skips to another circuit it also changes direction (clockwise or anticlockwise). If we transform such labyrinths into the rectangular form, we split the main axis along the central axial wall to which are aligned the turns of the pathway. Both halves are then flipped upwards. By this, the turns of the pathway come to lie on the left and right outer sides of the rectangular form. The pathway, however, is not interrupted. The entrance to the labyrinth and the way to the center lie on the outermost left and right verticals of the rectangular form.

However, there exist also labyrinths in which the pathway traverses the main axis. Two examples of such labyrinths have been repeatedly shown on this blog: the Snail Shell labyrinth by Erwin and the labyrinth of St. Gallen (see related posts). If we want to transform such labyrinths into the rectangular form, the pathway has to be interrupted in the positions where it traverses the (main) axis. This can best be demonstrated with the labyrinth of St.Gallen.

Figure 1. Labyrinth of St. Gallen

Fig. 1 shows the labyrinth with the Ariadne’s Thread inscribed and the Ariadne’s Thread isolated. Even it the Ariadne’s Thread, due to the construction of the labyrinth, appears slightly skewed, it is immediatly evident that the pathway in this labyrinth traverses the axis. On its way across the axis it follows the axis in full length from the outside in. Contrastingly the labyrinth has no central axial wall that would connect the innermost with the outermost wall.

If we want to transform this Ariadne’s Thread into the rectangular form, the axial piece of the pathway has to be split in 2 halves.

Figure 2. Transformed into the Rectangular Form

Fig. 2  from top to bottom shows the process and its result. As can be seen, the axial segment of the pathway is split on its full length (in two dashed lines), and these are flipped upwards on each side.

Figure 3. The Pattern

Fig. 3 shows the pattern once again. In the rectangular form, the Ariadne’s Thread cannot be drawn in one single line. Multiple lines, this case two interweaving lines, are needed for this. Beginning at the entrance on top left, the first line ends at the outer right side (dashed line). This is the right half of the pathway segment that traverses the axis and therefore was split. Its course is in direction from top to bottom. The second line begins as the dashed line on the outer left side, which is the corresponding left half of the pathway segment that traverses the axis. This line must be drawn in the same direction (from top to bottom) as the right half. Both halves of the same segment of pathway, of course, follow the same direction. These two halves now mark the outermost vertical lines of the rectangular form. The pathway segments for the entrance to the labyrinth and the access to the center lie further inside.

Related Posts:

### 2 Responses

1. […] The Pattern in Non-alternating Labyrinths […]

Like

2. […] brought here a posting to the Jericho labyrinth St. Gallen which probably shows the historically first crossing of the […]

Like

This site uses Akismet to reduce spam. Learn how your comment data is processed.